XJ (X350) V8-4.2L (2005)
Brake Pressure Hold Valve: Service and Repair
Brake Master Cylinder Pressure Transducer
Removal
1. WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. Wash hands thoroughly after handling,
as prolonged contact may cause irritation and dermatitis. If brake fluid contacts the eyes, flush the eyes with cold water or eyewash
solution and seek medical attention. If taken internally do not induce vomiting, seek immediate medical attention. Failure to follow these
instructions may result in personal injury.
Disconnect the battery ground cable. Refer to Battery.
2. Disconnect the brake master cylinder primary pressure transducer electrical connector.
3. CAUTION: If brake fluid is spilt on the paint work, the effected area must be immediately washed down with cold water.
Remove the brake master cylinder primary pressure transducer.
Installation
1. To install, reverse the removal procedure.
^
Tighten 30 Nm.
2. Bleed the ABS brake system.