XJ (X350) V8-4.2L (2005)
/v8-4.2l/Page-498002.png)
Installation
1. CAUTION:
-
The hanger insulators are constructed of a special material. Use only the correct specification insulators.
-
Alignment marks are provided for correct fitment of the muffler and tailpipe assemblies to the front muffler. Make sure the muffler and tailpipe
assembly aligns between the two tolerance markers. Failure to follow this procedure may result in damage to the vehicle.
NOTE:
-
Check the hanger insulators for damage or fatigue. Install new hangers if required.
-
Make sure the muffler and tailpipe is central in the bumper aperture.
-
Right-hand shown, left-hand similar.
To install, reverse the removal procedure.
-
Tighten to 55 Nm.
