XJ (X350) V8-4.2L (2005)
UPDATE THE ENGINE CONTROL MODULE SOFTWARE
CAUTION:
Ensure all ignition "ON" / ignition "OFF" requests are carried out; failure to perform these steps may cause damage to control modules
in the vehicle.
CAUTION:
A Jaguar-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.
1. Connect the Jaguar-approved Midtronics Vehicle Power Supply to the vehicle battery.
NOTE:
IDS must be loaded with IDS-DVD120_V6.04 or later and Calibration File 27 or later.
2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. From the Session Type selection screen, choose 'Diagnosis'.
5. Select the Selected Symptoms tab, and then select:
^
Electrical > Instruments > Warning Lamps > Engine Malfunction Lamp > Lamp Illuminated
6. Select 'continue'.
7. Select the Recommendations tab.
8. From the Recommendations tab, select Run to configure the Powertrain control module.
^
Follow all on-screen instructions to complete this task.
9. Exit the current session.
10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.
Disclaimer