XJ (X350) V8-4.2L (2005)
12.
Remove and discard the two pinion housing securing bolts (Illustration 11).
Caution:
Make sure the working surfaces are thoroughly clean to avoid contamination of the sensitive hydraulic components. Before the disconnecting
or removing any components, ensure that the area around the joint faces and connections is clean. Plug any open connections to prevent
contamination.
Note:
On removal the pinion shaft will rotate approximately 90 degrees counterclockwise.
13.
Using a nylon mallet, carefully release the pinion housing.
14.
Place the pinion housing assembly in a clean plastic bag, and seal to prevent contamination.
Caution:
It is imperative that no damage is caused to the seal register when removing the seal. Protect the seal register using lint free cloth.
15.
Carefully remove the pinion shaft inner seal (Illustration 12).