XJ (X351) V8-5.0L SC (2010)
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
INSPECT AND TIGHTEN WIPER ARM SECURING NUTS
NOTE:
Additional necessary windshield wiper repairs should be performed as a separate Warranty claim.
1. Ensure windshield wipers are in the parked position:
^
Turn ignition 'ON'.
^
Operate windshield wipers single wipe function, allowing the wipers to stop in the parked position.
^
Turn ignition 'OFF'.
2. Open the hood
CAUTION:
Use care when removing the wiper arm spindle nut cover to avoid damage.
3. Remove and retain the left-hand (LH) wiper arm spindle nut cover.
4. Loosen the wiper arm securing nut sufficiently to allow the wiper arm knuckle to realign with the wiper spindle.
5. Apply hand pressure on the wiper arm to ensure correct arm alignment to the spindle. (Figure 1)
6. Tighten the wiper arm spindle nut to 25Nm (18.5lbf ft).
7. Install the wiper arm spindle nut cover.
8. Repeat steps 3-7 to the right-hand (RH) wiper arm.
9. Close the hood.