XJ (X351) V8-5.0L SC (2010)
Parking Brake Control Module: Customer Interest
Brakes - Electronic Park Brake Re-Calibration Procedure
No: JTB00208
Issue: 1
Date: 22 NOV 2010
THIS BULLETIN REPLACES S206-02; CHANGES ARE HIGHLIGHTED IN GRAY
SECTION: 206
Electronic Park Brake Re-calibration Procedure
AFFECTED VEHICLE RANGE:
CONDITION SUMMARY:
PARTS:
No parts necessary
TOOLS:
No special tools required
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal warranty policies and procedures apply.
REPAIR PROCEDURE
RECALIBRATE THE ELECTRONIC PARK BRAKE MODULE
1. Reset the Electronic Park Brake (EPB) module:
^
Switch the ignition 'OFF'.
^
Refer to Workshop Manual section 414-01: Battery, Mounting and Cables > General Procedures > Battery Disconnect and Connect, and
disconnect the negative battery cable.