XJR (X300) L6-4.0L SC (AJ16) (1995)
Hood Latch Release Cable: Service and Repair
Fig. 1
-
Slacken the clamp bolt securing the cable to the lock actuator.
-
Disconnect the cable from the lock and from the mounting clip.
-
Release the cable from the bulkhead mounting clips and remove the tie wraps securing the cable to the pipes and harnesses.
-
Remove the cable from the remaining large tie wraps.
-
Open the front door.
-
Remove the underscuttle pad.
-
Pull the release handle and disconnect the cable from the release handle and bracket.
-
Pull the cable (Fig.1) through the bulkhead grommet and discard.
Refit in the reverse order of the removal procedure.