XJR (X300) L6-4.0L SC (AJ16) (1995)
Technical Service Bulletin # 13_14
Date: 960401
Front Seats - General Discomfort
13-14
DATE: 4/96
Sedan Range
Front Seats - Softer Cushion Pads -
Installation Instructions
MODEL
1995 MY
Sedan Range
VIN
720001 - 745999
ISSUE:
Seat cushions manufactured from a softer grade of foam pad were introduced in production from VIN 746000 in response to customer concerns of front
seat discomfort. The softer cushions can be retrofitted to Sedan Range vehicles within the above VIN range.
ACTION:
In case of a customer complaint of general discomfort from the front seats on Sedan Range vehicles within the above VIN range, determine by
questioning the customer whether the cushion is perceived as too hard. If so, install the softer seat cushions as described below.
PARTS INFORMATION:
The cushion part numbers are unchanged. All stock is now to the latest condition.
WARRANTY INFORMATION:
Installing Softer Front Seat Cushions
1.
Remove the seat headrest.
2.
Remove the end covers at the rear of both seat tracks. Remove both bolts securing the rear of the seat tracks.
3.
Move the seat completely to the rear.
4.
From the outside of the seat, remove the cover of the seat belt anchor bolt. Remove the bolts and release the seatbelt.
5.
Remove both bolts securing the front of the seat tracks.
NOTE: If both seats will be modified, repeat steps 1-5 for the opposite seat.
6.
Disconnect the negative battery cable.
7.
Raise the front of the seat for access and disconnect the harness connectors from the seat controls.
8.
Remove the seat assembly and place it on its side with the seat belt buckle facing up on a clean workbench.
9.
Disconnect the harness connector leading to the seat belt buckle.
10.
Remove the tie straps retaining the harness noting how the harness is routed to the buckle.