XJR (X300) L6-4.0L SC (AJ16) (1995)
Fuel Level Sensor: Service and Repair
Remove
-
Disconnect battery ground lead.
-
Remove battery/fuse cover.
-
Drain fuel tank.
-
Remove trunk floor carpet board.
-
Remove trunk front liner.
-
Disconnect fuel gauge tank unit feed wires (1).
-
Rotate the fuel gauge tank unit securing ring (2) using service tool 18G 1001 (6).
-
Remove ring (2).
-
Pull fuel gauge tank unit (3) approximately two inches out of the tank and turn 90° clockwise.
-
Raise the fuel gauge tank unit and withdraw the float arm (4) from the tank aperture.
-
Note the orientation for re-assembly.
-
Remove and discard the gasket (5).
Refit in the reverse order of the removal procedure.
NOTE: Always fit new gaskets, do not re-use existing gaskets.