XJR (X300) L6-4.0L SC (AJ16) (1995)
^
Remove bolt dust caps and socket head bolts (3 Fig. 1)
^
Remove the brake pads (4 Fig. 1).
Note: Ensure that the calliper is placed where the brake hose and harnesses are not stressed.
Note: Ensure the brake calliper piston is fully retracted and remains in that position until the pads are refitted
WARNING: BRAKE PAD / LINING DUST CAN, IF INHALED DAMAGE YOUR HEALTH. ALWAYS USE A VACUUM BRUSH TO
REMOVE DRY BRAKE PAD / LINING DUST. NEVER USE AN AIR LINE.
^
Remove track end rod securing nut.
^
Fit service tool JD 100 and break taper.
^
Undo and remove steering rack to cross member fixings and spacers.
^
Undo and remove the stabilizer bar link arm lower securing nut and bolt.
^
Undo and remove upper ball joint fixings and shims.
^
Undo and remove fulcrum shaft nut and damper lower mounting fixings.
^
Remove front wishbone.
^
Remove rear wishbone/stub axle assembly.
^
Clamp the front wishbone arm in to a vice mounted on a on a suitable work bench.
^
Ensure that the top hat of the bush faces upwards.
^
Cut and remove the top hat sides (Fig. 2) and remove assembly from vice.
^
Position the wishbone arm between press adaptor plates, fit service tool JD 143-4 (Fig. 3) and extract bush.