XJR (X300) L6-4.0L SC (AJ16) (1995)
^ Assembly and fitting is the reversal of this procedure taking note of the following:
-
Adhesive should be applied to axle shaft splines over a radial area of 30 to 50%.
-
For the initial setting, position the head of the hub carrier fulcrum to the mark previously made on the wishbone prior to checking and adjusting (if
required) rear wheel toe-in.
-
Renew all bolts that were originally fitted with thread locking adhesive.
-
Replace all locking wire and split pins (cotter pins).
-
Tighten all fixings to the specified torque.
-
Verify operation of brakes.
-
Renew all self locking nuts.
Note: The axle shaft nut is a self-locking item with a thread insert and must NOT be re-used.