XJR (X300) L6-4.0L SC (AJ16) (1995)
Fluid Pan: Service and Repair
Fluid Pan, Renew
FLUID PAN, RENEW
-
Open the hood and fit a suitable fender cover.
-
Raise the vehicle on a rack.
-
Drain the transmission lubrication system.
-
Slacken the downpipe catalyst to intermediate catalyst clamp securing bolts.
-
Slacken the intermediate catalyst to intermediate silencers clamp securing bolts.
-
Disconnect the intermediate catalyst pipe from the down-pipe.
-
lean the downpipe and intermediate pipe joint.
-
Release and remove the fluid pan securing bolts.
-
Remove the fluid pan (1 Fig. 1) and gasket (2 Fig. 1).
-
rain the residual fluid from the fluid pan.
-
Remove the fluid pan gasket.
-
Clean the fluid pan gasket, which can be re-used if in good condition.
-
Place the fluid pan gasket aside.
-
Remove the magnet (3 Fig. 1) from the fluid pan.
-
Clean the magnet and place on a clean surface.
-
Clean the transmission fluid pan joint face.
-
Clean the fluid pan.
-
Place the fluid pan aside.
-
Attach the magnet to the recess in a new fluid pan.
-
Fit and align a serviceable gasket to the fluid pan.
-
Fit the fluid pan and gasket to the transmission unit.
-
Fit and tighten the fluid pan securing bolts.