XJR (X300) L6-4.0L SC (AJ16) (1995)
Torque Converter Clutch Solenoid: Service and Repair
PULSE WIDTH MODULATOR (TCC SOLENOID), RENEW
-
Open the hood and fit a suitable fender cover.
-
Raise the vehicle on a ramp.
-
Drain the transmission lubrication system.
-
Remove the fluid pan.
-
Remove the fluid filter.
-
Disconnect the internal harness plug from the pulse width modulator.
-
Remove the modulator to valve body retaining clip.
-
Displace and remove the modulator from the valve body, noting the orientation.
-
Remove and discard the '0' ring seals from the modulator.
-
Place the modulator aside.
-
Fit new '0' ring seals to a new pulse width modulator.
-
Lubricate the '0' ring seals.
-
Fit and seat the modulator, in the correct orientation, to the valve body using a twisting motion.
-
Fit the pulse width modulator to valve body retaining clip.
-
Connect the internal harness plug to the modulator.
-
Refit the fluid filter.
-
Refit the fluid pan.
-
Lower the vehicle on the ramp.
-
Refill the transmission unit with fluid.
-
Remove the fender cover and close the hood.