XJR (X308) V8-4.0L SC (AJ26) (1998)
5. Release trunk release button harness connector from retaining clip and disconnect connector.
6. Slacken and remove the trunk upper trim finisher securing nuts.
7. Position upper trim finisher for access and withdraw release button harness grommet from trunk lid aperture.
8. Position upper trim finisher for access and slacken and remove release button securing screws.
9. Withdraw release button assembly from trim finisher.
Installation
1. Position trunk release button assembly on trim finisher and install securing screws.
2. Position trim finisher/release button assembly at trunk lid and route harness through lid aperture.
3. Position grommet over harness and install in trunk lid aperture.