XJR (X308) V8-4.0L SC (AJ26) (1998)
5. Depress and hold down brake pedal using special tool.
Position tool between brake pedal and seat frame.
Turn the tool wheel until the brake pedal is held 60 mm down from its released position.
6. Tighten bleed nipples to:
Front caliper bleed nipple 4 - 6 Nm.
Rear caliper bleed nipple 8 - 11 Nm.
Remove bleed tubes and containers.
7. Disconnect electrical connectors from ABS/TCCM.
Pull plunger upwards.
Disconnect electrical connector.
Disconnect electrical connector
8. CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.