XJR (X308) V8-4.0L SC (AJ26) (1998)
/v8-4.0l_sc_(aj26)/Page-513002.png)
9. Remove the chain tensioner blade.
Remove the pivot bolt which secures the tensioner blade.
Remove the tensioner blade.
10. Clean and inspect all relevant components.
Installation
1. Install the chain tensioner blade.
Position the tensioner blade to the cylinder block.
Install the retaining/pivot bolt and tighten it to 12-16 Nm.
2. Remove the Ty-Strap from the chain.
3. Install the Timing Chain Tensioner - Primary. The camshafts may need to be turned slightly to provide slack in the chain, on the tensioner side.
4. Install the VVT Bush Carrier Assembly.
5. Install the Timing Cover.
6. Move the engine compartment cover from the service position and connect the gas struts.
7. Remove the paint protection sheets and close the cover.
8. Connect the battery and install the battery cover.
Refer to the Battery Reconnection Procedure.