XJR (X308) V8-4.0L SC (AJ26) (1998)
5. WARNING:
BEFORE PROCEEDING, IT IS ESSENTIAL THAT ALL 'SERVICE PRECAUTIONS' ARE READ AND UNDERSTOOD.
Disconnect the three valve hoses.
Pull off the vacuum pipe.
Release the clip and disconnect the upper vapor hose.
Release the clip and disconnect the lower vapor hose. Plug the hose (note the warning above).
Installation
1. Remove the two mounting rubbers from the old valve and fit to the new valve.
2. Fitting a new purge valve assembly is the reverse of the removal procedure.
3. Connect the battery and fit the battery cover.
Refer to the Battery Reconnection Procedure Refer to 'Battery, Service and Repair.' See: Starting and Charging/Battery/Service and Repair
4. Carry out a leak test of the evaporative emissions system.