XJR (X308) V8-4.0L SC (AJ26) (1998)
6. Secure the driveshaft wrench 205-053 to the output shaft flange.
7. Remove the output shaft flange.
Using a suitable tool relieve the 'slaked' portion from the output shaft keyway.
Remove and discard the flange nut using a suitable socket and resisting rotation with special tool 205-053.
Check the flange seal diameter for damage and renew if necessary.
8. Remove and discard the oil seal.
Use a proprietary seal removing tool, taking care NOT to damage either the shaft or the housing.
Installation
1. Installation is the reverse of the removal procedure noting the following: