XJR (X308) V8-4.0L SC (AJ26) (1998)
![background image](/jaguar/xjr_(x308)/v8-4.0l_sc_(aj26)/Page-1331001.png)
Wiring Harness: Service and Repair
Removal
1. Disconnect the battery ground cable.
2. Open the engine compartment and the paint protection sheets.
3. Raise the vehicle for access.
4. WARNING: TRANSMISSION FLUID MAY CAUSE SEVERE BURNS, ENSURE THAT ALL SAFETY PROCEDURES ARE
OBSERVED AND THAT THE RECEPTACLE FOR WASTE HAS SUFFICIENT CAPACITY.
Drain the transmission fluid.
Carefully remove the drain plug and discard the sealing washer.
5. Remove the harness heatshield lower fixing.
Remove the screw heatshield/fluid pan clamp.
6. Remove the harness heatshield.
Pull the heatshield from under the clip.