XK-8 Convertible (X100) V8-4.0L (AJ26) (1997)
/v8-4.0l_(aj26)/Page-530010.png)
6. Reconnect the electrical connector to each fuel injector.
7. Install the induction elbow support; working from the left hand side.
Install the upper bolt to the induction elbow support bracket. Tighten to 16 - 20 Nm.
Tighten the lower two bolts at the induction elbow support bracket. Tighten to 16 - 20 Nm.
Connect the engine breather T-piece to the induction elbow.
Connect the vacuum pipe to the front of the induction elbow.
8. Install the induction elbow support; working from the right hand side.
Install the upper bolt to the induction elbow support bracket. Tighten to 16 - 20 Nm.
Reconnect the vacuum pipe to the center of the induction elbow.