XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
15. Fit crossbeam front mounting-brackets.
Align mounting bracket to crossbeam.
Fit front bolts: do not tighten at this stage, (one bolt on convertible vehicles).
Fit and tighten rear bolt.
Tighten front bolts.
Repeat procedure to fit opposite-side mounting bracket.
16. Lower and remove jack from underneath crossbeam,
17. NOTE: Make sure steering wheel and wheels are in the central position before fitting steering column.
Fit steering column to pinion shaft.
Move column downwards onto pinion shaft.
Fit and tighten bolt.
18. Remove blanking plugs from PAS hoses and pinion housing ports.
19. Connect return hose to pinion shaft housing.
Apply clean PAS fluid to a new O-ring and fit to hose.
Connect and fully seat hose.