XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
5. Remove caliper housing from caliper carrier.
-
Remove anti-rattle spring.
-
Remove dust covers.
-
Remove guide pins.
-
Remove and tie caliper housing aside.
NOTE: The inner brake pad is fitted with a clip which secures the pad into the caliper piston.
6. Remove brake pads from caliper housing.
-
Discard brake pads.
7. Clean all mating surfaces and remove brake dust, see WARNING above.
8. Repeat above procedure to remove opposite side brake pads.
Installation
CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work, with
clean water.
NOTE: Clean caliper piston to pad mating surface.