XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
CAUTION: Always install new brake pads, irrespective of the condition of the original pads, when renewing brake discs.
CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work, with
clean water.
CAUTION: Note the condition of pins and 'R' clips and replace if necessary.
5. Install brake pads into caliper housing.
-
Slowly retract caliper pistons. Install pads.
-
Position anti-rattle spring.
-
Install pins.
-
Install 'R' clips.
6. Repeat above procedure to install opposite side brake disc.
7. Fit wheels.
8. Remove stands and lower vehicle.
CAUTION: Remove brake fluid spillage immediately from paint work, with clean water.
9. Check brake fluid level.
-
Check brake fluid level is at the maximum mark.
-
Remove cloth.
-
Fit cap.
10. Remove paint work protection covers, and close engine compartment.
11. Start the engine and repeatedly press the brake pedal until brake pressure is evident.