XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
2. Install fluid reservoir to master cylinder.
-
Remove plugs from reservoir.
-
Install reservoir, making sure reservoir is fully seated.
-
Install locating pin.
3. Install master cylinder to brake booster.
-
Install seal.
-
Install master cylinder, make sure master cylinder rod locates brake booster rod.
4. Install and tighten nuts to 21-29 Nm.
5. Install pedal housing, brake booster and master cylinder assembly.
6. Install plenum cover.
7. Install windshield wiper arm and blade assembly.
8. Connect battery ground cable.
9. Bleed brake system.
10. Remove paint-work protection covers and close engine compartment.