XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
18. install the crankshaft position sensor.
Install the sensor to the flywheel housing and install the securing bolt. Tighten to 8-12 Nm.
Install the access grommet to the housing.
19. Lower the ramp.
20. Install new seals to the VVT bush carrier, Bank 1.
Install the new sealing ring (scarf jointed) to the carrier bush groove.
Install a new O-ring to the carrier oil-way.
21. Install the VVT bush carrier to the cylinder block.
Lubricate the seal (scarf jointed) and the bush.
Install the bush carrier assembly.
Check that the seals are in place and that the ring dowels are engaged squarely. Fully locate the assembly as much as possible by hand pressure.
Install the three securing bolts. Tighten to 19-23 Nm.