XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
Engine Control Module: Service and Repair
Removal
1. Disconnect battery ground cable. See: Starting and Charging/Battery/Battery Cable/Negative/Service and Repair
2. Remove ECM housing cover.
3. Disconnect electrical connectors.
4. Lift ECM from housing.
Installation
1. Installation is a reversal of the removal procedure. See Battery Reconnection Procedure. See: Starting and Charging/Battery/Service and Repair
NOTE: A replacement ECM may only be obtained from an authorized Jaguar dealer and MUST be ordered against the VIN.
NOTE: Check condition of housing seals and replace as necessary.
2. Synchronize ECM, KTM and BPM using PDU.
3. Complete engine set-up using JDS/PDU.