XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
3.
You should get a reading between the parameters (see table) for the relative temperature.
Resistance is measured in Ohms at the engine management connector EM013:
1.
Disconnect the engine management connector EM013.
2.
Check the resistance between pin 020 and pin 029 (sensor ground camshaft position sensor).
3.
You should get a reading between the parameters (see table) for the relative temperature.
Crank and Cam Sensor signals are displayed on WDS:
See Illustration 1 for an example of a good crank signal as seen on the WDS oscilloscope.
Note:
The oscilloscope was set to 1 volt/div and 10 ms/div. The gap in the waveform represents the missing tooth on the flywheel.