jaguar Workshop Repair Guides

Jaguar Workshop Service and Repair Manuals

Ignition Relay > < Ignition Coil - Coil on Plug - Bank 1 (Right)|Page 4868
Page 1
background image

Ignition Control Module: Service and Repair

Removal

1. Disconnect battery ground cable. See: Starting and Charging/Battery/Battery Cable/Negative/Service and Repair 

2. Disconnect connector from ignition control module.

3. Remove fixings securing module. 

Remove module

 
Installation

1. Installation is a reversal of the removal procedure. Refer to the Battery Reconnection Procedure. See: Starting and Charging/Battery/Service and

Repair 

Ignition Relay > < Ignition Coil - Coil on Plug - Bank 1 (Right)|Page 4868