XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
/v8-4.0l_(aj26)/Page-67001.png)
Adaptive Damping Control Module: Service and Repair
Control Module-Adaptive Damping
Removal
1. Remove trunk floor carpet.
2. Remove battery cover and disconnect ground cable from battery terminal.
3. Remove adaptive damping control module nuts.
4. Position control module for access and disconnect harness connector.
5. Remove control module from vehicle.
Installation
1. Position control module in trunk and connect harness connector.
2. Finally position control module and install nuts.
3. Connect ground cable to battery terminal and install battery cover.
4. Install trunk floor carpet.
