XK-8 Coupe (X100) V8-4.0L (AJ26) (1998)
2. Fit the oil seal.
Lubricate the housing seal bore.
Lubricate the outside diameter of the seal.
Using seal replacer 307 - 378 drive the seal squarely into position.
3. Refit the drive flange.
Use a new nut. Tighten the flange nut to the specified torque figure.
Stake the nut to the output shaft.
4. Refit the bolts securing the driveshaft and tighten to the specified torque figure.