XK-8 Coupe (X100) V8-4.0L (AJ27) (1999)
/v8-4.0l_(aj27)/Page-1101003.png)
10. Remove the hub from the bearings as follows:
a. Place the vertical link assembly on the special supporting tool No. JD225, or equivalent.
b. Using a suitable press, and press tool JD224, or equivalent, press the hub from the bearings.
11. Press the bearing assembly from the vertical link as follows:
a. Remove & discard the inboard circlip.
b. Position the press bearing removal tool No. JD237, or equivalent, on the bearing inner cone.
c. Press the bearing assembly from the vertical link.
d. Discard the bearing assembly.
12. Clean the vertical link bearing bore.
13. Clean the hub bearing diameter.
NOTE: Do not use abrasives.
INSTALLATION
1. Install a new outboard circlip in the groove of the vertical link.