XK (X100) V8-4.2L (2005)
/v8-4.2l/Page-613006.png)
41. Release the side tension cords and rear tension cables and remove headlining from vehicle.
42. NOTE: On certain early model year vehicles, press-stud fixings securing the the headlining to the frame must be removed and replaced by fir-tree
fixings. The procedure for this modification is detailed in Technical Bulletin Number 501-14.
Clean rivet swarf from convertible top area and remove double-sided tape from front of frame.
Installation
1. Place headlining in vehicle, positioning and seating rear of lining in rear bow rail slot.
2. Move padding bag forward for access and check that lining is fully seated on rear bow rail.
3. Route rear tension cables through the headlining piping.
4. Connect rear tension cables onto frame and fit and fully seat retaining bushes.
5. Move padding bag rearward for access.
6. To prevent damage to headlining during fitting, apply protective tape to leading end of centre bow rail.
7. Ensuring correct orientation, feed centre bow rail into the headlining.
