XK (X100) V8-4.2L (2005)
21.
Undo and remove the oil cooler return pipe/hose to intermediate connector-securing bolt, (Illustration 5).
22.
Disconnect and remove the oil cooler return pipe/hose from the intermediate connector.
23.
Displace and discard oil cooler pipe 0-ring seal.
24.
Install suitable blanking plugs to cooler pipe/hoses.
25.
Place the new oil cooler return pipe/hose to the front.
26.
Displace and remove the blanking plugs from the cooler pipe/hose.
27.
Install and fully seat the new 0-ring seal to the cooler return pipe/hose.
28.
Lubricate the new 0-ring seal.
29.
Reposition and align the oil cooler return pipe/hose to the intermediate connector and reconnect.
30.
Install and tighten intermediate connector securing bolt (Illustration 6).
31.
Lubricate the oil cooler feed and return pipe/hoses 0-ring seals.
32.
Reposition and align the oil cooler feed and return pipe/hoses to the engine port.
33.
Reconnect the oil cooler feed pipe/hoses to the engine port.
34.
Reposition and install the oil cooler pipe/hose retaining plate.
35.
Install and tighten the retaining plate securing bolt.