XK (X100) V8-4.2L (2005)
11.
Remove the oil cooler feed pipe/hose to intermediate connector-securing bolt (Illustration 3).
12.
Disconnect and remove the oil cooler feed pipe/hose from the intermediate connector.
13.
Displace and discard oil cooler pipe 0-ring seal.
14.
Install suitable blanking plugs to cooler pipe/hoses.
15.
Place the new oil cooler feed pipe/hose to the front.
16.
Displace and remove the blanking plugs from the cooler pipe/hose.
17.
Install and fully seat the new 0-ring seal to the cooler feed pipe/hose.
18.
Lubricate the new 0-ring seal.
19.
Reposition and align the oil cooler feed pipe/hose to the intermediate connector and re-connect.
20.
Install and tighten intermediate connector securing bolt (Illustration 4).