XK (X100) V8-4.2L SC (2003)
6.
Back out terminal (blue/yellow wire) from connector SC2 cavity 4. Illustration 2. Refer to Figure 0.2 of the 2003 MY XK Electrical Guide.
Note:
Use tool fitted with blade "B" from the Jaguar Harness repair kit to perform the previous operation.
Note:
Take care not to disconnect the terminal (yellow/blue wire) from connector SC2 cavity 1.
7.
Place the new two-way connector to front; ensure that the anti-back-out device is open.
8.
Insert the disconnected terminal (blue/yellow wire) into the cavity of the new connector. Illustration 3.
Note:
The terminal must be fitted into the two-way connector cavity so as to connect to the diode yellow wire.