XK (X150) V8-4.2L (2008)
Installation
1. CAUTION: Do not lubricate the components.
Partially install the crankshaft rear oil seal.
Make sure the components are clean and dry.
Carefully remove the transit sleeve, leaving the seal on the crankshaft.
2. CAUTION: Make sure the seal is installed parallel.
Using the special tool, install the crankshaft rear oil seal.
> Tighten the special tool nuts evenly and progressively to fully install the seal.
3. Install the torque converter flexplate.
4. Check and top-up the engine oil.
5. Connect the battery ground cable.