XK (X150) V8-4.2L (2008)
1. Install the keyless start control module.
-
Connect the electrical connector.
-
Install the Torx screws.
2. Install the keyless start control module trim cover.
-
Install the Torx screws.
3. Install the floor console side panel trim.
-
Carefully align and secure the clips.
-
Tighten the Torx screws to 6 Nm (4 lb.ft).
-
Install the opposite hand.
4. Install the floor console rear panel.
-
Align the lugs and secure the clips.
5. Install the floor console veneer trim panel.
6. Install the rear seat armrest.
7. Connect WDS to the vehicle and configure a new module.