XK (X150) V8-4.2L SC (2007)
/v8-4.2l_sc/Page-284001.png)
Coolant Line/Hose: Service and Repair
Coolant Manifold - Vehicles With: Supercharger
Removal
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
1. Remove the cover and disconnect the battery ground cable.
2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Drain the cooling system.
4. Remove the supercharger belt.
5. Release the engine wiring harness.
> Remove the 2 bolts.
6. Disconnect the coolant manifold to radiator hose.
> Remove the clip.
7. Disconnect the thermostat housing to radiator hose.
> Release the clip.
8. Disconnect the coolant manifold to coolant reservoir hose.
> Release the clip.
9. Disconnect the coolant manifold bleed hose.
> Release the clip.
10. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
11. Disconnect the cylinder block coolant hose.
> Release the clip.
