XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
Ignition Switched Ground
This symbol represents an ignition switched ground and refers the user to Figure 02.1.
This symbol without a suffix indicates CRANK. Ground is completed in ignition switch key position III (ENGINE CRANK).
The suffix I indicates auxiliary ground. Ground is completed in ignition switch key positions I (AUXILIARY) and II (IGNITION).
The suffix II indicates ignition ground. Ground is completed in ignition switch key positions II (IGNITION) and III (ENGINE CRANK).
Figure Number Reference Flag
This symbol refers the reader to a figure number only. It does not refer to a flag with the same number on a different figure.
As used in Figures 01.1 through 02.1, the reference flag refers the user to a continuation of the circuit. In this instance, the user matches the number to a
Power Supply or Ground symbol to trace the circuit.
In most other cases, it is not necessary to refer to another figure for completion of a circuit, as the reference flags are used to indicate parallel circuits and
circuits that share components. Most of the circuits where this situation occurs are overlapped to avoid the necessity for cross-referencing to another
figure. Exceptions to this rule are instances where signals are transmitted to or received from other system circuits. When circuits are not overlapped,
they are noted by (CIRCUIT CONTINUED).
BPM Because the Body Processor Module appears numerous times, the abbreviation BPM is used in the reference tags on Figures 01.2 and 02.1 in
order to conserve space.
Control Module I/O, Data Link, Signal And Networks
These six symbols are employed to assist the user in visualizing the 'logic' of circuits containing control modules. The symbols identify control module
input, output, data link, signal ground and network pins. These symbols are also employed on the corresponding data page.
Wire Color Code Identification
N
Brown
O
Orange
B
Black
S
Slate
W
White
L
Light
K
Pink
U
Blue
G
Green
P
Purple
R
Red
BRD
Braid
Y
Yellow
When a wire has two color code letters, the first letter indicates the main color and the subsequent letter indicates the tracer color.
Wiring Harness Identification Codes
Code
Description
AC
Air Conditioning (Climate Control)
AN
Generator Suppression Module
AS
Generator to Starter
BB
Trunk Bridging Link
BC
Main Power Distribution
BL
Trunk Lid
BT
Trunk
DD
Door, Driver
DP
Door, Passenger
EL
Engine Management Speed Control Link