XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
4.
Using the rotor-nut socket, remove the rotor-nut.
INSTALLATION
1.
Fit the rotor-nut to the hub.
2.
Tighten the rotor-nut to 270-330 Nm.
3.
Install a new rotor-nut spring clip into the hub retaining holes and, if aligned, into the castellated slots of the rotor-nut.
4.
It may be necessary to tighten the rotor-nut further, to engage the spring clip into the castellated slots of the rotor-nut.
Warning:
Do not slacken the rotor-nut to engage the spring clip.
5.
Remove the hub from the vice.