XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
1. Install the new main seals to the cam cover.
Install the new outer seal.
Install the two new spark plug aperture seals.
Install the seal to the variable camshaft timing oil control solenoid aperture.
2. Install the securing screws to the cam covers.
Install a new sealing ring to each screw assembly.
Install the screws to the cam covers. Each screw is retained by the cam cover gasket.
Refer to the tightening sequence diagram for details of where to install the studs.
3. Apply RTV sealant WSS-M4G320-A3 to two places on the joint between the timing cover and the cylinder head.
The application of sealant must be 3 mm diameter by 12 mm long. Install the cam cover immediately after applying the sealant.
The cover should be installed directly to the head without smearing the sealant.