XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
/v8-4.0l_sc_(aj27)/Page-236003.png)
6. Install the crankshaft setting tool 303-531.
Position the crankshaft so that the special tool fully engages into the timing slot on the drive plate.
7. Lower the vehicle on the ramp.
8. Install the camshaft locking tool 303-530 to Bank 1 camshafts, aligning the shafts slightly as necessary.
9. CAUTION: Use a length of steel strip that will not fall into the timing cover.
Protect the upper face of the timing cover from scratches, when removing the bolt which secures the sprocket.
Place a flat piece of steel strip along the timing cover horizontal jointing face, adjacent to the exhaust camshaft sprocket.
Secure the steel strip in place with adhesive tape.
