XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
Control Module Pin Out Information
This information is included to assist the user in identifying and locating components, connectors and grounds.
When network data is required for the understanding of a particular circuit, the user is directed to Computers and Controls / Information Bus /
Description and Operation.
Where circuits include a Control Module, Pin Out information is provided with values for "active" and "inactive" states. The values listed are
approximately those that can be expected at the control module connector pins with all circuit connections made and all components connected and
fitted. "Active" means a load is applied or a switch is ON; "inactive" means a load is not applied or a switch is OFF. This information is provided to
assist the user in understanding circuit operation and should be used FOR REFERENCE ONLY.
Reference Symbols
NOTE: In the examples shown on this page, an 'X' is used where a number would appear on an actual Figure.
Reference Symbols
Reference symbols are used for three purposes:
-
To allow the user to complete the individual system circuit to power supply or ground
-
To refer the user to a related circuit
-
To identify control module inputs, outputs and signal grounds
Battery Power Supply
This symbol represents a direct battery power supply and refers the user to Figure 01.1, 01.2 or 01.3.
Ignition Switched Power Supply
This symbol represents ignition switched power supply and refers the user to Figure 01.1, 01.4 or 01.5.
The suffix I indicates auxiliary power. Power is supplied in ignition switch key positions I (AUXILIARY) and II (IGNITION).
The suffix II indicates ignition power. Power is supplied in ignition switch key positions II (IGNITION) and III (ENGINE CRANK).
The suffix E indicates engine management switched power. Power is supplied in ignition switch key positions II (IGNITION) and III (ENGINE
CRANK) under ECM control.