XKR Convertible (X100) V8-4.0L SC (AJ27) (2001)
Control Module: All Technical Service Bulletins
A/T - Harsh Cold Engagement/ Poor Shift Quality
V8 XJ Series/XK
2000-02 MY XK Range
2000-03 MY V8 XJ Series
Shift Quality Issues/Harsh Engagement With Engine Cold- ZF 5HP26 - Install New Transmission Control Module
On some 2000-02 MY XK NA vehicles and 2000-03 MY XJ vehicles within the above VIN ranges, customers complain of the following transmission
shift quality issues, most noticeable when the engine air intake temperature is between 20°C and 30°C and when the engine coolant temperature is below
40°C. Under these conditions the engine speed will increase to 1300 rpm for an initial 30 seconds and then reduce to 1000 rpm. During the initial period
when the engine speed is at 1300 rpm, the customer may complain of the following conditions:
With no throttle application the transmission hesitates and then thumps into gear when shifting from neutral to drive.
With no throttle application the transmission hesitates and then thumps into gear when shifting from neutral to reverse.
In case of a confirmed customer complaint of the above condition on vehicles within the above VIN ranges, install a new Transmission Control Module
(TCM) as described below.
If any DTCs are stored in the TCM or Engine Control Module (ECM), carry out any repairs as a separate Warranty Claim and before installing the
Install new TCM (see Workshop Manual, JTIS CD ROM, section: 307-01A, SRO 44.15.32).
Warranty claims should be submitted quoting the information found in the table. This will result in payment of the stated time and, where applicable
parts/miscellaneous expense codes as listed.