XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
3. Fit latch assembly and cable to door. Refer to Door Latch, Service and Repair.
4. Reposition secondary water shedder in door.
5. Fit main water shedder to door.
6. Fit door casing.
7. Perform the Battery Reconnection Procedure See: Starting and Charging/Battery/Service and Repair and fit battery cover.
Driver Door Lock Mechanism
Removal
1. Turn ignition key to position II.
2. Motor door glass to fully raised position.
3. Turn ignition key to position 0.
4. Remove battery cover and disconnect ground cable from battery terminal. See: Starting and Charging/Battery/Battery Cable/Negative/Service and
Repair
5. Remove door casing for access.
6. Remove door water shedder.
7. Position PVC secondary water shedder for access.
8. Slacken and remove the door glass rear runner lower securing screws.
9. Reposition door glass rear runner.
Mark the position of the glass rear runner upper securing screw.
Slacken and remove the upper securing screw and move the runner away from the glass.