XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
10. Measure hub face run-out.
-
Position the gauge so that the pointer contacts the hub face.
-
Slowly rotate the hub one revolution, the hub run-out must not exceed the specification.
-
If the hub exceeds the maximum run-out specification replace the hub.
11. If the hub run-out is within specification replace brake discs.
12. Install caliper to hub carrier.
-
Install and tighten bolts to 60 Nm.
CAUTION: Retracting the caliper piston may cause the fluid reservoir to over-flow. Remove brake fluid spillage immediately from paint work with
clean water.
CAUTION: Note condition of pins and replace if necessary.
13. Install brake pads to caliper.
-
Slowly retract caliper pistons.
-
Install pads.
-
Position anti-rattle spring.