XKR Coupe (X100) V8-4.0L SC (AJ27) (2000)
Wiper Control Module: Service and Repair
Removal
1. Remove battery cover and disconnect ground cable from battery terminal. See: Starting and Charging/Battery/Service and Repair
2. Remove glove box for access. Refer to Body and Frame, Interior Trim. See: Body and Frame/Interior Moulding / Trim/Glove Compartment
3. Remove two bolts securing module to passenger side dash panel.
4. Disconnect harness connector from module and remove module from vehicle.
Installation
1. Position module at dash panel and connect harness connector.
2. Install module bolts.
3. Install glove box.
4. Perform the Battery Reconnection Procedure See: Starting and Charging/Battery/Service and Repair