Cherokee 2WD L4-150 2.5L VIN H TBI (1988)
Taped Turn Signal Switch Wire Harness Connector
13. Disconnect the turn signal wire harness connector from the bracket located at the lower end of the steering column.
CAUTION: Wrap tape around the turn signal switch wire harness connector to prevent it from becoming entangled during removal.
14. Remove the plastic protector from the wire harness.
Turn Signal Switch Retaining Screw
15. Remove the turn signal switch retaining screws, dimmer switch actuator arm, to remove the switch. Guide the switch straight up and out of the
steering column.
16. Remove the windshield wiper switch wire harness and all the other wire harnesses located within the steering column.
17. Insert the ignition switch key into the key/lock cylinder. Turn the key to the ON position.
CAUTION: Do not attempt to remove the key warning buzzer switch and contacts separately. It separated, the contacts can detach and drop into
the steering column.
