Cherokee 2WD L4-150 2.5L VIN P MFI (1991)
Console: Service and Repair
MINI-CONSOLE REMOVAL
1. Remove the transmission shift lever handle knob. For vehicles with automatic transmissions, remove shift handle by pulling handle upward.
2. For vehicles with a manual transmission, loosen the locknut and un-thread the shift knob from the shaft.
3. Remove the automatic transmission and transfer case shift indicator bezel by prying upward to release them.
4. Disconnect the lamp socket from the bezel.
5. Remove the console retaining screws.
6. Disconnect the wire harness connector.
7. Remove the mini-console from the transmission tunnel.
INSTALLATION
1. Position the mini-console on the transmission tunnel, connect the wire harness connector and install the retaining screws. Tighten the screws to 1
Nm (13 in. lbs.) torque.
2. Position the shift indicator bezel at the console and connect the lamp socket to the bezel. Install the bezel in the console.
3. Install the shift lever handle/knob. For automatic transmissions, push the handle downward until it is engaged. For manual transmissions, thread
the knob onto the shaft and tighten the locknut.
Park Brake Cover With Mini-Console
PARKING BRAKE HANDLE COVER REMOVAL
1. Detach the rear of the cover from the base and pivot it upward.
2. Remove the retaining screws from the cover base.
3. Remove the trim cover from the from the floor.
INSTALLATION
1. Position the cover on the floor and install the retaining screws.
2. Pivot the cover to the closed position and engage the locking tab.