Cherokee 2WD L6-4.0L VIN S (1998)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the three screws that secure the seat side shield to the outboard seat cushion frame.
3. Pull the seat side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
4. Unplug the power seat switch wire harness connector from the switch.
5. Remove the seat side shield from the vehicle.
Power Seat Switch Remove/Install
6. Remove the two screws that secure the power seat switch to the inside of the seat side shield.
7. Remove the power seat switch from the seat side shield.
8. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).
